high speed grinding lateral

• 

  An Investigation of High Speed Grinding with Electroplated …

  200011 · High-speed grinding was carried out using single-layer electroplated diamond grinding wheels in the speed range of 40–200 m/s. The important grinding characteristics, such as material removal mode, residual stress, surface roughness, etc., were correlated with the maximum uncut chip thickness ( hm) and the scallop height ( Sg ).

  view more
• 

  Micro-fracture behavior of a single-aggregated cBN grain …

  202271 · Micro-fracture behavior of a single-aggregated cBN grain and its relation to material removal in high-speed grinding of Ti–6Al–4V alloys - ScienceDirect

  view more
• 

  Grinding Machines - BENTELER Glass Processing Equipment

  The BENTELER flat glass grinding machines convince due to their optimal grinding results based on precision, speed and process reliability.

  view more
• 

  Effect of minimum quantity lubrication on surface integrity in high ...

  2018101 · In the present work, high-speed grinding of alumina was performed under MQL-neat oil, MQL-soluble oil (5% concentration in water) and conventional wet grinding environment with the single layer electroplated diamond grinding wheel.

  view more
• 

  Surface roughness modeling for grinding of Silicon Carbide …

  2017111 · In the study of brittle materials grinding, the indentation fracture mechanics approach likens abrasive-workpiece interactions for grinding of ceramics to small-scale indentation events [22]. There exist generally two principal crack systems [23], the lateral and median cracks.

  view more
• 

  Optimal Analysis on Rail Pre-grinding Profile in High-speed …

  With the development of high-speed railway,more and more attention has been focused on the rail damage caused by wear and rolling contact fatigue,and it is found that rail service life could be extended by the pre-grinding technology.To determine the optimal pre-grinding profile,a probability model of wheel-rail contact based on the Monte Carlo method is …

  view more
• 

  Analytical modelling of both parallel and cross grinding with …

  2020219 · The distribution of the undeformed chip thickness (UCT) in the wheel-workpiece contact area is important to analyze the grinding-induced damage and the grinding force on brittle materials. Cross grinding (CG) and parallel grinding (PG) are two basic modes in aspherical grinding. However, fewer researches provided the calculation …

  view more
• 

  PLASTICITY AND FRACTURE OF INORGANIC GLASSES AT …

  2024523 · At higher speeds plastic grooving takes place and indication to very high temperatures are observed in the grooves. The plastic behavior of the glasses shows a glass and speed depend­ ent change which has been associated to a change from quasi-isothermal yielding to adiabatic flow at higher temperatures in the scratched zone. 1.

  view more
• 

  Laser-assisted grinding of silicon nitride ceramics: Micro …

  2022111 · Kizaki et al. [ 32] developed diamond grinding wheel for yttrium stabilized zirconia ceramic laser hot working, found that the introduction of laser heat can reduce the grinding forces and tool wear, laser-induced high temperature can reduce the fracture strength of yttrium stabilized zirconia ceramics.

  view more
• 

  Crystals | Free Full-Text | Review on Research and …

  202332 · Hard brittle materials such as ceramics and crystals are commonly utilized in various industries, including information technology, mechanical engineering, and semiconductors. These materials, known for their high brittleness and hardness but low fracture toughness, pose challenges in efficient and high-quality machining. Current …

  view more